ArmorLink
Device Setup
Click & Run
Install Click & Run on a supported ESP32 and build your own device without writing code.
About this log
The last 400 diagnostic events stay in this browser tab across reconnects and page reloads. Download the log after a problem and review it before sharing. Configuration values are omitted and common secrets are redacted. Nothing is uploaded automatically.
- 01 Connect
- 02 Board
- 03 Flash
Connect your board.
Plug it in with a USB data cable. We’ll check which firmware fits.
Open this page in a desktop Chromium-based browser to connect your board and install firmware.
New board or existing Armorlink node — both work here.
Is this your board?
Check the name and variant printed on your board.
Board details
Ready to install.
Version & release details
Back up settings and Actions, and disconnect power from attached actuators.
Checking firmware catalog …
No precompiled firmware for your board yet? Use the Click & Run source to configure, compile and flash it manually with Arduino IDE or PlatformIO. Or .
Firmware installed. Make it yours.
Close the installation dialog and reconnect your board in the Node Configurator to add Components and Actions. Press RESET if needed.
Open Action Builder