ArmorLink

Device Setup

From your first connection to your next custom build. Choose the starting point that matches your hardware — we’ll guide you from there.

Firmware already installed

Connect & fine-tune

Configure your
existing device

Your device already runs ArmorLink? Connect it over USB and make it work the way you want, directly from your browser.

Dial in your hardwareAdjust servo positions, timings, lights and the other settings your firmware exposes.
Bring your actions to lifeRun and test device actions. On compatible firmware, create your own sequences in the Action Builder.
Keep a setup that worksImport or export setup profiles and reuse your configuration when you need it.

For official Nodes, custom ArmorLink firmware
and devices already running Click & Run.

No coding required

Install & create

Turn a supported ESP32 into your own ArmorLink device. Install ready-to-use firmware, then build its behavior visually.

Get your board readyConnect over USB, confirm your board and install the matching firmware from your browser.
Add the hardware you needSet up servos, LED strips, GPIO, buttons and DFPlayer audio using the board’s supported pins.
Build something of your ownCombine actions, waits and conditions. Add log messages and a startup sequence that runs when your device boots.

For a new build or a supported ESP32
you want to use with Click & Run.